Troubleshooting - Carbest 81909 User Instruction

UK
TROUBLE SHOOTING
!
WARNING: During troubleshooting, if there is a need to connect/disconnect the
unit from battery, follow the steps outlined in »Important Safety Instructions« at the
front of this manual and the warning »To reduce risk of a spark near the battery«.
Common problem
Unit not charging
Battery Connection
If the charger does not connected properly, charging will not start. Make sure the
charger is connected to the battery and the connection points are clean and making
a good connection or make sure no reverse connections at the battery.
Charging Completion
Charge completion is indicated by the charging status indicator turning on ( LED
indicator shows fully charged state). This means that the charger has stopped char-
ging. NOTE: If the battery is not removed, the charger can detect the voltage. When
battery voltage is lower than 13 V, the charger will charge for battery automatically.
Maintaining a battery
The unit maintains 6V/ 12V batteries, keeping them at fully charged. It can charge
small batteries and maintain both small and large batteries. If you are maintaining
a fully charged large battery, you are properly utilizing the battery charger.
!
NOTE: The maintain mode technology utilized in this charger allows you to safely
charge and maintain a healthy battery for exhausted periods of time. However,
problems with the battery, electrical problems in the vehicle, improper connections
or other unanticipated conditions could cause excessive current draws. As such,
occasionally monitoring your battery and the charging process is recommended.
Carbest Batterie Ladegerät | Battery Charger 81909 Carbest Batterie Ladegerät | Battery Charger 81909
Possible solutions
Check that the charger is properly connected to
a live AC Outlet.
Check that the correct battery selection setting
has been selected for the battery being charged.
Check that the correct current selection setting
has been selected for the battery being charged.
Make sure output connections are secured.
Check correct polarity connections.
22