Table of Contents
Advertisement
Suunto Smart Heart Rate Belt
5. Care and support
5.1. Handling guidelines
Both the Suunto Smart Sensor module and chest strap should be rinsed with fresh water after
each use.
CAUTION: Do not pull the Suunto Smart Sensor module off the belt. This may damage
the chest strap connectors. Unsnap one side at a time.
The chest strap should be machine washed in 30° C after every 2-3 exercises. See the belt
tag for further washing instructions.
CAUTION: Do not machine wash the Suunto Smart Heart Rate Belt module. Machine
washing damages the module.
NOTE: The Suunto Smart Sensor module should last a long time but the the chest strap
will wear out like any textile will and may need to be replaced when the heart rate reading
becomes unreliable. See 5.2. Troubleshooting
5.2. Troubleshooting
The transmission range of the Suunto Smart Heart Rate Belt can be three meters or more
under ideal conditions.
However, for best results, minimize obstructions between the Suunto Smart Heart Rate Belt
and your sports watch or mobile device. When not on wrist, keep the watch or mobile in front
of you or to one side in a pocket or on a belt.
NOTE: Your body can block the signal.
If the Suunto Smart Heart Rate Belt does not seem to be sending heart rate data even without
obstructions, try any of the following:
1. Ensure the belt contact areas (electrodes) are wet and the belt Suunto logo is turned the
correct way.
2. Adjust the belt so that it fits tighter against your chest.
3. If your skin tends to remain dry during a workout, use electrode gel.
4. Check that Bluetooth is on in the device your belt is paired with.
5. Change the battery in the sensor and re-pair with your sports watch or mobile device.
If the Suunto Smart Heart Rate Belt seems to send incorrect data, try any of the following:
1. Ensure that the sensor is attached correctly to the belt with both snaps fitted.
2. Pair the belt again with your Bluetooth
3. Mashine wash the chest strap in 30°C.
4. Renew the chest strap.
5.3. Battery
The Suunto Smart Heart Rate Belt uses a 3-Volt lithium cell (CR 2025).
To replace the battery:
Ⓡ
Smart-enabled device.
7
Advertisement
Table of Contents
