Focon Showtechnic Expolite Tour-Cyc 540 User Manual page 31

Fan Set: the speed of the inbuilt fan of the fixture can be controlled depending on the temperature of
the LED-unit (Auto), or with non-stop full speed (High).
Wireless DMX: The currently saved wireless DMX-connection can be reset (Yes) in the submenu
Wireless DMX, or the process can be cancelled (No).
Test: gives the user the opportunity to test different functions of the LEDs step-by-step (ON) or to end
the test (OFF).
Factory Reset: resets the fixture to factory settings (Yes) or cancels this process (No).
Keylock: In the menu Keylock the password protection of the fixture is activated or deactivated. If
set ON the fixture is password protected when started. 30 seconds after the last setting the menu is
locked again. To be able to make changes in the menu the password UP - DOWN - UP - DOWN -
ENTER needs to be typed in.
Info-Menu
MENU
System Info
PERSON
In the Info-Menu (System Info) different operating data of the fixture can be monitored:
Firmware: In the submenu Firmware the currently installed firmware version is shown.
Temperature: In the submenu Temperature the current temperature of the LED-unit (LED Temp)
canbe monitored. This is shown either in degree Celsius or in degree Fahrenheit depending on the
setting made in the submenu Temp Unit.
Time Info: In the submenu Time Info it is possible to monitor the total operating hours of the fixture
(Power on) or the operating hours after the last switch-on of the fixture (Last Run Hrs).
Software Version Vxxx
Firmware
Temperature LED Temp
Temp Unit
Time Info Power on
Last Run Hrs
E-31
xxxC
Fahrenheit
Celsius
XXX (Hours)
XXX (Hours)