Connection Method And Steps For System Communication - Gree GMV Series Owner's Manual

(2) All communication wires are connected by screws.
(3) If a single communication wire is not long enough and needs to be connected, the
connected joint must be welded or pressure-welded. Do not simply twist the wires
together.
4.6.4 Communication address
Auto addressing technology is adopted for IDU and ODU. No need to set address codes
manually. Only the addresses of master unit and central control are needed to be set (address
of central control is only needed when there are multiple refrigeration systems).
Note:
When installing remote monitor or central controller, displacement on indoor units' project
codes must be made. Otherwise, there will be collision malfunction of the project codes. For
detail operation methods, please refer to the Installation and Maintenance Manual.

4.7 Connection Method and Steps for System Communication

4.7.1 Communication connection between IDU and ODU
Note:The centralized controller can be installed when it is necessary.
Connect IDU and ODU via terminal D1/D2 of wiring board XT2. Below are the connection
graphics of single unit and modular units:
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Fig.42
Fig.43 Connection of single unit
34
GMV DC Inverter VRF