Yamaha CDX-390 Owner's Manual page 15

Manual tape-programming
This is for recording desired tracks in any desired
order onto a tape.
1
Follow steps 1 – 4 on page 14.
2
PROG
3
Program desired tracks (to be recorded on side A) in
any desired order.
1
4
7
* Programmed track numbers light up on the display. You
can select a track which can be programmed for the
remaining time of (the side of) the tape from track
numbers flashing on the display, but you cannot select a
track number extinguished from the display.
4
When track selection for side A is finished, press the
TAPE button.
A pause mode is programmed.
Notes on tape programming
•
To check, cancel or correct program data, refer to page 13.
* In checking the program data, note that "Pu" appears
between track numbers for side A and side B.
•
Up to a maximum of 25 tracks can be programmed. If,
however, the PAUSE mode is inserted, it is counted as one
track.
PROGRAM
A TOTAL
REMAIN
1 2 3 4 5 6 7 8 9 10 11 12
+
2 3
10
5 6
8 9 0
TAPE
OPEN/CLOSE DIMMER TIME
PROG TAPE CLEAR PEAK
2
SPACE S/F RANDOM
REPEAT
+
1 2 3 10
4 5 6
7 8 9 0
SKIP
PAUSE PLAY
7
SEARCH INDEX STOP
5
Select the track numbers (to be recorded on side B) in
any desired order.
6
Begin recording on the tape deck and press the PLAY
button on this unit at the same time.
7
The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording and,
at the same time, press the PLAY or PAUSE button on
this unit.
Notes
•
If, in step 3 or 5, "E rr" appears on the display, the track
number just selected cannot be programmed because there
is not enough time remaining on the tape. However, at this
time, if any other track number is flashing continuously on
the display, you can program it instead of the
unprogrammable one.
•
In step 3 or 5, each time a selection is made, the track
number and the tape's remaining time will be displayed, and
then the display will change to indicate the next program
number.
•
CD synchronized recording function can be used if your tape
deck is compatible with it. If so, in step 6 and 7, press the
SYNCHRO button and then press the PLAY button on this
unit's remote control transmitter. Recording automatically
begins. (For details, refer to page 18.)
•
This function can be used to program up to track number 24.
If the disc has more than 24 tracks, track number 25 and
thereafter will not be programmed.
4
3, 5
6, 7
+
1 2 3 10
4
5 6
7 8 9 0
15