Advertisement
NOTES:
o
Replace low impedance (outside of specifications) speakers with the correct
impedance to prevent this from occurring.
o
If you continue to use the low impedance (outside of specifications) speakers and
you ran the Auto Calibration, check your SPEAKER SETUP and individual
speaker LEVEL to reduce any speaker LEVEL with a positive gain to 0.0dB or
less.
4. To isolate the problem, do the following:
1. Turn off the home audio device, and remove all speaker wires from the back.
Then turn the device back on and check if the issue is resolved. If it is still having
the same issue, turn off the device again and let it rest for at least 30 minutes
before turning it on again.
2. Inspect the speaker cords. If a cord is frayed or in contact with another terminal,
an error will occur. Fix the connection to prevent a short circuit.
3. Make sure the speaker impedance is within the recommended range. If the
impedance is not correct, sound will not come out properly and the speaker may
be damaged. If speakers that are within the recommended impedance range, check
the connections. If the speakers being used is within the suitable range and is still
not working, there may be a malfunction or some other flaw within the speakers.
Test by using a different set of speakers if available.
Advertisement
