Periodic Maintenance; Storage And Winterizing; Replacement Parts - Pentair BLUEFURY LITE Installation Manual

Periodic Maintenance

Periodically inspect the BLUEFURY
Cleaner and its components. Replace and/or repair any worn
or damaged components. Failure to follow instructions or
improper installation of the cleaner can result in damage to
the cleaner, pool finish, or vinyl liner.
The following parts are wear items that should be inspected
periodically and replaced as needed:
Tires
The tires are designed to protect the bottom of your pool
and provide traction. Tires will wear and need to be replaced
occasionally.
Debris Bags
The cleaner comes with a general purpose bag and is used
for all debris types. Replace bag when the fabric is torn or
punctured.
Note: To prolong the life of your cleaner, remove it from
pool before adding chemicals.
Sweep Hose
The sweep hose is provided to help keep hard to reach
corners of your pool clean. Replace sweep hose scrubber as
necessary if used.
Sweep Hose Roller Rings
Your sweep hose has a series of roller rings to protect the
sweep hose. Replace the rings as needed. Ensure the roller
rings rotate freely.
Backwashing the Pool Filter
Always disconnect the cleaner from the pool wall before
cleaning or backwashing the pool filter. After cleaning or
backwashing, let the pool filtration system and booster pump
run for a minimum of five minutes to flush out the return lines
before reconnecting the cleaner.

Storage and Winterizing

You may leave the wall adapter in the wall and store the
hoses straight, without any kinks. If storing the hose coiled,
be sure to lay the hose straight in the sun for 12 to 24 hours
before using again.
Cleaning the Wall Fitting Debris Screen

Replacement parts

An up-to-date copy of the replacement part can be found on our website : www.pentairpooleurope.com
371885 (REV 12/2016)
LITE Pressure Side Pool
®
Inside the wall fitting is a stainless steel screen that acts as a
secondary filter. This screen captures debris that may have
passed through the pool filter.
The wall fitting debris screen should
be cleaned once a week. Failure to
regularly clean the debris screen could damage the
cleaner.
IMPORTANT!
A dirty screen may be an indication of
potential issues in your pool filter system and you may need
to contact your local pool professional.
Note: Running the cleaner without the debris screen can
damage the cleaner and void the warranty.
To clean the debris screen:
1. Switch the booster pump and then the filtration pump off.
2. Remove the wall fitting from the wall adaptor.
3. Pull the screen out from inside the wall fitting.
4. Rinse thoroughly until clean and insert back inside the
wall fitting.
5. Whenever cleaning, backwashing or repairing the pool filter,
also clean the wall fitting screen after your first cleaner cycle.
Figure 17
Mender Nut
Hose Connector
Wall Fitting
Debris Screen
Cleaning the Debris Screen
MAINTENANCE
Feed Hose
12