Yamaha RX-V595aRDS Owner's Manual page 41

Adjusting the delay time
You can adjust the time difference between the beginning of the
sound from the main speakers and the beginning of the sound
effect from the rear speakers.
The larger the value, the later the sound effect is generated.
This adjustment can be individually made to all programs.
Program
1. DOLBY PRO LOGIC
DOLBY DIGITAL
DTS
2. DOLBY PRO LOGIC/Enhanced
DOLBY DIGITAL/Enhanced
DTS/Enhanced
3. 70 mm MOVIE THEATER
70 mm MOVIE THEATER – DOLBY D.
70 mm MOVIE THEATER – DTS
4. MONO MOVIE
5. TV SPORTS
6. DISCO
7. ROCK CONCERT
8. CONCERT HALL
Adjusting the output level of the center, right rear and left rear speakers, and subwoofer
If desired, you can adjust the sound output level of each
speaker even if the output level has already been set in
"SPEAKER BALANCE ADJUSTMENT" on pages 21 to 23.
Notes
• The output level of the center speaker cannot be adjusted
when the DISCO, ROCK CONCERT or CONCERT HALL
program is selected, and the input signal is analog, PCM
audio, or encoded with Dolby Digital in 2-channel.
Speaker
CENTER
RIGHT REAR
LEFT REAR
SUBWOOFER
Memory back-up
The memory back-up circuit prevents the stored data from being lost when this unit is set in the standby mode. If, however, the
power plug is disconnected from the AC outlet or the power is cut due to temporary power failure for more than one week, the latest
values for the delay time and the center/rear/subwoofer output levels that were set will automatically return to the preset values. If
so, they can be re-set by simply following the adjustment method on page 40.
Notes
• Adding too much delay will cause an unnatural effect with
some sources.
• When + or – is pressed, the sound is momentarily inter-
rupted.
Control range (ms)
15 to 30
0 to 15
0 to 15
15 to 30
0 to 15
0 to 15
15 to 30
1 to 99
1 to 99
1 to 99
1 to 99
1 to 99
1 to 99
1 to 99
• If the function "CNTR" in the SET MENU mode is set to the
NONE position, the sound output level of the center speaker
cannot be adjusted. This is because, in this mode, the center
speaker sound is automatically output from the left and right
main speakers.
• Once the output level has been adjusted, the level will be the
same for all digital sound field programs.
Control range (dB)
MIN, –20 to +10
MIN, –20 to +10
MIN, –20 to +10
MIN, –20 to 0
Preset value
20
5
5
20
5
5
20
16
16
49
9
40
16
44
Preset value
0
0
0
0
41