Speaker Balance Adjustment - Yamaha RX-V595aRDS Owner's Manual

SPEAKER BALANCE ADJUSTMENT

This procedure lets you adjust the sound output level balance between the main, center and rear speakers by using the built-in test
tone generator. When this adjustment is performed, the sound output level heard at the listening position will be the same from
each speaker. This is important for the best performance of the digital sound field processor, the Dolby Digital decoder, the Dolby
Pro Logic decoder and the DTS decoder.
The adjustment of each speaker output level should be done at your listening position with the remote control.
After completing the adjustment of the output level for each speaker, use VOLUME (
listening position to check if the adjustments are satisfactory.
2
3 4 4,7
Set the SELECTOR DIAL to the AMP/TUN or DSP position
on the remote control.
or
1
Set VOLUME to the " " position.
Front panel
1
2
2
Turn the power on.
Front panel
3
Select the main speakers to be used.
* If you use two main speaker systems, press both A and B.
) on the remote control at your
5,9
6
8
Remote control
or
Front panel
21