Yamaha RX-V595aRDS Owner's Manual page 25

4
For a DVD/LD or TV/DBS source, the current input
mode is also shown.
* To change the input mode for the DVD/LD or TV/DBS
source, press INPUT MODE (or the button that you
have pressed to select the input source in step 3 on
the remote control) once or more until the desired
input mode is shown on the display. (See page 26 for
details on switching the input mode.)
Front panel
or
5
Select the main speakers to be used.
Front panel
* If you use two main speaker systems, press both A and B.
6
Play the source. (See page 28 for detailed information
on tuning.)
7
Remote control
8
Input mode
* These controls are only effective for the sound from the
When you have finished using this unit
Press STANDBY/ON on the front panel again or STANDBY on
the remote control to set this unit in the standby mode.
Adjust the volume to the desired output level.
Front panel
or
If desired, adjust BASS, TREBLE, BALANCE, etc.
and use the digital sound field processor (see pages 37
to 38).
BASS: Turn this control clockwise to increase (or
counterclockwise to decrease) the low-
frequency response.
TREBLE: Turn this control clockwise to increase (or
counterclockwise to decrease) the high-
frequency response.
BALANCE: Adjust the balance of the output volume
from the left and right speakers to
compensate for any sound imbalance
caused by the speaker location or
listening room conditions.
Front panel
main speakers.
Front panel Remote control
or
Remote control
25