Nordson Coolwave 2 Instruction Sheet
Internal blower lamphead harness upgrade
Hide thumbs
Also See for Coolwave 2:
- Product manual (117 pages) ,
- Instruction sheet (6 pages) ,
- Instruction sheet (6 pages)
Advertisement
Quick Links
Coolwave
WARNING: Allow only qualified personnel
to perform the following tasks. Follow the
safety instructions in this document and all
other related documentation.
WARNING: This equipment operates at
high voltages and is therefore potentially
dangerous. The electrician servicing this
equipment must take all precautions.
Description
Use this instruction to upgrade the harness
assembly in the Coolwave
lamphead.
Replacing Harness
Remove Top Cover
See Figure 1.
1. Disconnect the unicable from the lamphead.
2. Remove the top blower cover by removing the
six M4 x 10 screws (three front and three rear)
and set aside.
3. Remove the top cover.
E 2018 Nordson Corporation
r
2 Internal Blower Lamphead
r
2 internal blower
Instruction Sheet
Harness Upgrade
WARNING: Isolate the equipment at the
main disconnect or lock out before
removing any of the cover panels.
The harness upgrade kit includes the harness
assembly and adapter plate mounting screw and
washer.
Figure 1
Removing Blower Screws
P/N 1613103-01
Part 1613103-01
Advertisement
Related Manuals for Nordson Coolwave 2
Summary of Contents for Nordson Coolwave 2
- Page 1 1. Disconnect the unicable from the lamphead. 2. Remove the top blower cover by removing the six M4 x 10 screws (three front and three rear) and set aside. 3. Remove the top cover. Figure 1 Removing Blower Screws Part 1613103-01 E 2018 Nordson Corporation...
- Page 2 4. Remove the blower from the lamphead. Figure 7 Removing Bottom Cover Figure 4 Removing Bolts and Washers Part 1613103-01 E 2018 Nordson Corporation...
- Page 3 3. Remove all the hardware holding in the harness. NOTE: Retain all hardware for installing new harness. a. Remove two capacitor screws (2) and washers (1). Capacitor Capacitor Figure 10 Removing Hardware and Faston Terminals Figure 9 Removing Capacitor Hardware Part 1613103-01 E 2018 Nordson Corporation...
- Page 4 Violet wire to bottom terminal Green Violet Figure 14 Installing Bracket Screws Reinstall Covers Figure 12 Installing Bulb Wires 1. Reinstall base cover and the blower. 2. Reconnect blower plug. 3. Reinstall top cover and reconnect unicable. Part 1613103-01 E 2018 Nordson Corporation...
- Page 5 (BLUE) (BLUE) (BROWN) (VIOLET) (GREEN) (WHITE) (BLACK) (WHITE) (GRAY) 10016998 Figure 15 Ring Terminals and Board Connectors (some parts not shown for clarity) Parts Part Description Note 1613102 KIT, upgrade, lamphead harness, internal blower Part 1613103-01 E 2018 Nordson Corporation...
- Page 6 Coolwave 2 Internal Blower Lamphead Harness Upgrade Issued 08/18 Original copyright date 2018. Coolwave, Nordson, and the Nordson logo are registered trademarks of Nordson Corporation. All other trademarks are the property of their respective owners. Part 1613103-01 E 2018 Nordson Corporation...