Yamaha RX-V480 Owner's Manual page 14

TO RECORD A SOURCE TO TAPE
1
Select the source to be recorded.
MONITOR
VCR TAPE
COPY
* To dub from tape to tape, refer to the "Notes" shown at
right.
* When you select LD/TV, TUNER, CD or PHONO, make
sure that neither TAPE nor VCR is also selected.
2
Play the source and then turn the VOLUME control
up to confirm the input source. (For detailed information
on the tuning operations, refer to the page 16.)
3
Set the tape deck or VCR to the recording mode.
4
To monitor the audio and/or video signals being
recorded, press the input selector switch for the audio
or video tape recorder being used to make the
recording.
MONITOR
VCR TAPE
COPY
14
INPUT
LD/TV TUNER CD PHONO
INPUT
LD/TV TUNER CD PHONO
1, 4
Notes
To dub from tape to tape, only the following method of
dubbing can be performed.
SOURCE
VCR (or tape deck)
connected to the VCR
terminals.
DSP, VOLUME, BASS, TREBLE and BALANCE control
settings have no effect on the material being recorded.
2
RECORDER
Tape deck connected to
the TAPE terminals.