Yamaha RX-V361 Owner's Manual page 61

Problem
The sound suddenly The protection circuitry has been activated
goes off. because of a short circuit, etc.
The sleep timer has turned off this unit.
The sound is muted.
Sound is heard from Incorrect cable connections.
the speaker on one
side only.
Incorrect settings in "SP LEVEL".
Only the center When playing a monaural source with a
speaker outputs
CINEMA DSP program, the source signal
substantial sound. is directed to the center channel, and the
front and surround speakers output effect
sounds.
No sound is heard "CENTER" in "SPEAKER SET" is set to
from the center
"NONE".
speaker.
One of the HiFi DSP programs (except for
5ch Stereo) has been selected.
No sound is heard "SUR. LR" in "SPEAKER SET" is set to
from the surround "NONE".
speakers.
This unit is in the "STRAIGHT" mode
and a monaural source is being played
back.
No sound is heard
"BASS OUT" in "SPEAKER SET" is set
from the subwoofer. to "FRNT" when a Dolby Digital or DTS
signal is being played.
"BASS OUT" in "SPEAKER SET" is set
to "SWFR" or "FRNT" when a 2-channel
source is being played.
The source does not contain low-
frequency bass signals.
Cause
Check that the impedance setting is correct.
Check that the speaker wires are not touching each
other and then turn this unit back on.
Turn on this unit, and play the source again.
Press N MUTE or Q VOLUME +/– on the remote
control to resume audio output.
Connect the cables properly. If the problem persists,
the cables may be defective.
Adjust the "SP LEVEL" settings.
Set "CENTER" to "SML" or "LRG".
Try another sound field program.
Set "SUR. LR" to "SML" or "LRG".
Press B STRAIGHT on the front panel so that
"STRAIGHT" disappears from the front panel
display.
Set "BASS OUT" to "SWFR" or "BOTH".
Set "BASS OUT" to "BOTH".
Troubleshooting
Remedy
See
page
13
—
—
28
14-17
29
45
31
45
33
46
46
57
En