Setting The Manufacturer Code - Yamaha RX-V1200 Owner's Manual

Setting the Manufacturer Code

You can control other components by setting a
manufacturer code. A code can be set up in each
component control area.
The following table shows factory-set component
(Library: component category) and the manufacturer code
for each area.
Input area Component category
(Library)
A
PHONO
TUNER TUNER
CD
V-AUX VCR
CBL/SAT CABLE
MD/TAPE
CD-R CD-R
D-TV/LD
VCR 1 VCR
VCR 2/DVR VCR
DVD DVD
1 Press an input selector button or Å to select
the component you want to set up.
SYSTEM
POWER STANDBY SLEEP 6CH INPUT
A
PHONO TUNER CD
V-AUX CBL/SAT MD/TAPE CD-R
D-TV/LD VCR 1 VCR2/DVR DVD
2
Press and hold LEARN for about 3 seconds
by using a ballpoint pen or similar object.
"SETUP" and the selected component name appear
alternately in the display window.
LEARN
Notes
• Press LEARN for at least 3 seconds, otherwise the learning
process is started.
• If you do not press any button within 30 seconds during step 3,
the setup process is canceled. If this happens, start over from
step 2.
Manufacturer
LD YAMAHA
TV –
YAMAHA
CD YAMAHA
–
–
MD YAMAHA
YAMAHA
TV –
–
–
YAMAHA
3
Press u / d to select the name of your
component's manufacturer.
You will find the names of most worldwide audio-
video manufacturers in alphabetical order in the
display window.
+
TV VOL
CH CH
TV MUTE
– +
SELECT
PRESET PRESET
TV VOL
–
If you want to change a library (component
category), press j / i. You can set a different
component from the input selector name.
Library choices: DVD, LD, CD, CD-R, MD, TAPE,
TUNER, TV, CABLE, DBS, SAT, VCR
Note
If the manufacturer of your component has more than one codes,
try each of them until you find the correct one as checking if it
works following step 4.
4
Press one of the buttons shaded below to
check if it works for the component being
set. If it does, the manufacturer code setting
has been correctly made.
POWER
TV
REC
DISC SKIP
LEVEL
+
TITLE
TV VOL
TV INPUT
y
• If you continuously want to set up another code for another
component, press TV MUTE/SELECT and repeat steps 1, 3
and 4.
5
Press LEARN again to exit from the setup
mode.
LEARN
Notes
• If you have already programmed a remote control function for
a button, the function by learning programming takes priority
over the setup manufacturer code's function.
• "ERROR" appears in the display window when pressing
buttons other than indicated in each step, or more than one
button at once.
REMOTE CONTROL FEATURES
POWER
AMP
AV
AUDIO
+
VOL
–
MUTE
SET MENU
MENU
A/B/C/D/E
43