Exchanging Preset Stations - Yamaha RX-396RDS/396 Owner's Manual

Natural sound stereo receiver

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

When the automatic preset tuning is finished;

The display shows the frequency of the last preset station.

Check the contents and the number of preset stations by

following the procedure of the section "To recall a preset

station" on page 18.

To recall a preset station

Simply follow the procedure of the section "To recall a preset

station" on page 18.

RX-496RDS, RX-396RDS

A recalled station is shown by the frequency or station name

on the display.

RX-496, RX-396

A recalled station is shown by the frequency on the display.

Notes

You can replace a preset station by another FM or AM

station manually by simply following the procedure of the

section "To store stations" on page 18.

RX-496RDS and RX-396RDS only

The automatic preset tuning search will be performed

through all RDS network frequencies until stations are stored

up to E8. If the number of received stations is not enough to

be stored up to E8, the search is finished automatically after

searching all frequencies.

With this function, only RDS stations with sufficient signal

strength are stored automatically. If the station you want to

program is weak in signal strength, tune to it in monaural

manually and program it by following the procedure of the

section "To store stations" on page 18.

* There may be a case that this function cannot receive a

station which could be received by the automatic tuning

method. This is because this function receives a large

volume of PI (Program Identification) data along with the

station.

RX-496 and RX-396 only

If the number of received stations is not enough to be stored

up to E8, the search is finished automatically after searching

all frequencies.

With this function, only FM stations with sufficient signal

strength are stored automatically. If the station you want to

program is weak in signal strength, tune to it in monaural

manually and program it by following the procedure of the

section "To store stations" on page 18.