Connecting Audio Components; Connecting A Cd Player; Connecting A Cd Recorder Or Md Recorder; Connecting A Turntable - Yamaha AV RECEIVER RX-V730 Owner's Manual

IPi'li'li'l_lNi'F
• Connecting a CD player
Connect the coaxial digital output jack on your CD player
to the DIGITAL INPUT CD jack.
• The AUDIO jacks are available for a CD player which does not
have coaxial digital output jack.
• Connecting a CD recorder or MD
recorder
Connect the optical digital signal input jack on your CD
recorder or MD recorder to the DIGITAL OUTPUT MD!
CD-R jack for digital recording.
Connect the optical digital output jack on your CD
recorder or MD recorder to the DIGITAL INPUT MD!
CD-Rjack to play a source from your recording
component.
• The AUDIO jacks are available for an CD recorder or MD
recorder which does not have optical digital input or output
jack.
• Once you have connected a recording component to this unit,
keep its power turned on while using this unit. If the power is
off, this unit may distort the sound from other components.
• DIGITAL OUTPUT jack and analog OUT (REC)jacks are
independent. Only digital signals are output from DIGITAL
OUTPUT jack and analog signals from OUT (REC)jacks.
• Connecting a turntable
Connect the output jacks on your turntable to the PHONO
jacks.
PHONO jacks are for connecting a turntable with an MM
or high-output MC cartridge. If you have a turntable with
a low-output MC cartridge, use an in-line boosting
transformer or MC-head amplifier when connecting to
these jacks.
• Connect your turntable to the GND terminal to reduce noise in
the signal. Please note that this connection may increase noise
with some record players.
_) I °UTPUT
Turntable I
I
LGND<_ ....
CD player
COAXIAL
OUTPUT
r
CD recorder or
MD recorder
OPTICAL
OUTPUT
OPTICAL
INPUT
indicates signal direction
__= indicates left analog cables
__ indicates right analog cables
__ indicates coaxial cables
_'_ indicates optical cables
16