Clare Controls ClareOne Installation Sheet

ClareOne Siren Installation Sheet
Last modified: 05/28/20
Part Number: CLR-C1-ZWSRN
Introduction
This guide briefly introduces the ClareOne Siren, part number
CLR-C1-ZWSRN.
Figure 1: ClareOne Siren callouts
Important safety information
Please read this and the online guide(s) at
https://www.clarecontrols.com/helpcenter. Failure to follow the
recommendations set forth by Clare Controls may be
dangerous or cause a violation of the law. The manufacturer,
importer, distributor, and/or reseller will not be held responsible
for any loss or damage resulting from not following any
instructions in this guide or in other materials.
© 28MAY20 Clare Controls, LLC.
WARNING:
test only when wearing appropriate hearing
protection.
The Siren is intended for indoor use in dry locations only. Do
not use in damp, moist, and/or wet locations.
Programming
The following instructions will step you through installing the
ClareOne Siren and connecting it to your ClareOne Z-Wave
network.
To add the siren to the ClareOne Z-Wave network:
1. Plug the siren into the desired power outlet.
Note: Do not plug the siren into a receptacle controlled by
a switch.
2. Use FusionPro or FusionPro Mobile to put your ClareOne
panel into Z-Wave Discovery mode.
Refer to page 40 of the
1918).
3. Press the Action button on the siren.
When the siren successfully joins the ClareOne Z-Wave
network, its LED flashes twice and turns to a solid color for
2 seconds before turning off.
Note: If the LED flash 3 times before turning off, it did not
join the Z-Wave network; remove the siren and then
repeat the above steps.
The ClareOne Siren is now a part of the ClareOne Z-Wave
network.
To test the siren's speaker system manually: Press and
hold the Action button for 5 seconds.
WARNING: Test only when wearing proper ear protection.
Siren speaker emits tones up to 105dB that can cause hearing
damage.
1 / 2
To prevent possible hearing damage,
FusionPro User Guide (DOC ID
DOC ID – 1963 • Rev 03