Advertisement
Operation, Installation, and Maintenance Instructions
DO NOT OPERATE WITH THE TUBE REMOVED FROM THE DUCT!!
1. Mark the position at which you have decided to mount the UV ozone tube. Place the tube holder as close to the
center of the duct as possible. Make sure there is sufficient depth for the tube (15 inches).
2. Using a 1.5 - 2.5 inch hole saw drill a
hole at the position marked in step 1.
Note: if you do not have an appropriate
sized hole saw, you can use tin sheers or
any other method you wish but try not to
leave any pieces of metal that will ob-
struct the UV light.
3. Place the UV tube bracket plate over the hole with the black plastic tube
mount in the center of the hole with the stickers on the outside as shown.
Mark the 4 holes in the corners, Remove the mounting plate and pre drill the
4 holes with a 3/32" or smaller drill bit.
Place the mounting plate back in position and using the stainless steel screws
provided screw the plate in place. Do not tighten the screws completely,
slightly less than 1/8" gap is desirable. There is a silicone foam seal that is 1/8
inch thick, this foam will NOT completely compress on a furnace/air conditioner
duct.
4. Place the provided ozone resistant Nor-
prene seal ring in the middle of the ceramic
socket on the tube, slide the tube into the
tube mount, being careful not to push it
past the Norprene seal. Install the plastic
retaining nut and tighten very tight.
5. Next place the control box in the
desired place and mark the 4 mount-
ing holes. Make sure the control box
is being mounted in a location that
will allow the 2 ft or 10 ft cable to
reach the UV tube. Pre drill the 4
holes with a 3/32" or smaller drill bit.
Place the box back in place and install
the 4 provided stainless steel screws.
Ozone Solutions
DISCONNECT POWER BEFORE SERVICING
DO NOT LOOK AT UV LIGHT
6. Plug the UV cable from the control
box into the UV tube. Plug the DC
plug from the desktop adapter into
the control box. Make sure the power
switch is turned off and then plug the
desktop adapter into the wall recep-
tacle.
Refer to the operation instructions for
setting and operation.
HVAC-2200
712-439-6880
www.ozonesolutions.com
Advertisement
