Table of Contents
Advertisement
7.2.1.
Sensor Settings: Sensitivity Configuration
The Sensitivity must be defined here so that DLT-SA6100 Screen Blanking Solution detects
whether or not the vehicle is in motion or stationary. The sliding controller provides five setting
levels: high / medium / low and two intermediate values (between high & medium and between
medium & low).
The following criteria determine which value should be set:
Condition and evenness of the ground on which the vehicle is moving.
Type of vehicle: different vibration strength of electric vehicles, petrol vehicles, etc.
Where is the VMT fitted on the vehicle? Vibrations vary depending on the mounting
location (console, under the roof, etc.).
What has been used to mount the VMT to the vehicle? Vibrations vary depending on the
mounting type (long or short RAM mounts, ADLoG mounting bracket, etc.).
NOTE
High
Mid High
Medium
Medium Low
Low
High
Mid High
Medium
Medium Low
Low
DLT-SA6100 Manual V1.10
The Sensitivity level that needs to be set for the VMT depends on a wide range
of criteria and must be determined on a case by case basis.
The following information on the Sensitivity setting can therefore be regarded
as non-binding recommendations.
If the vehicle is smooth running (e.g. electric vehicles) and the
ground is relatively level.
If the vehicle is vibrating heavily (e.g. petrol vehicles) and the
ground is uneven.
Configuration and System Test
35 / 43
Advertisement
Table of Contents
