Getting Started - Duramaxx Inspex 4000 Manual

Remote control
1 Enter: to view or play the video
2 Up: navigate up / to the previous menu item
3 REC: start recording
4 Setup: system settings and recording capabilities
5 Power: switch system on
6 Down: navigate down / to the next menu item
7 Exit: exit or stop the current menu item
8 Left: navigation to the left
9 Right: navigate to the right
1. IMPORTANT: When you connect the camera to the monitor, the unit must be switched
off. Otherwise it could be damaged.
2. Screw the camera to the cable connector (Figure A) and connect the cable reel to the
monitor (Figure B).
3. Insert the fuse into the connector on the side of the battery compartment.
4. With the power cord, connect the power connector of the device with a mains outlet.
(If you want to use battery power, connect the DC 12V output cable of the battery
with the DC 12V input and press the battery button (you can also charge the battery
during operation). Proceed as follows: plug the charging adapter into the socket and
charging port. Connect the DC 12 V output cable of the battery with the DC 12V input
and press the battery button).
Attention: Pay attention to the proper use of the charging adapter and the power cord.
Otherwise the device may fail to operate properly or the battery could be damaged.
5. Press the power button on the front of the monitor.
6. Insert the camera into the pipe and roll up the cable until you have reached the desi-
red depth.
7. Press the LED button and adjust the menu brightness.
8. Start the recording when desired.
18

Getting Started