Yamaha YAS-70 Owner's Manual page 31

Problem
The remote control
does not work for
operating this system.
\
■ Tuner
Problem
FM stereo reception is
noisy.
There is distortion, and
clear reception cannot be
obtained even with a
good FM antenna.
The desired station
cannot be tuned into with
the automatic tuning
method.
Previously preset
stations can no longer be
tuned into.
■ iPod
Note
In case of a transmission error without a status message appearing in the front panel, check the connection to your iPod (page 12).
Status message
Unknown iPod
The iPod being used is not supported by
this system.
iPod connected
Your iPod is properly stationed in a
Yamaha iPod universal dock (such as
YDS-10, sold separately) connected to the
DOCK terminal of this system, and the
connection between your iPod and this
system is completed.
Disconnected
Your iPod was removed from a Yamaha
iPod universal dock (such as YDS-10,
sold separately) connected to the DOCK
terminal of this system.
Cause
This system may be operated outside the
remote control operation range.
The remote control sensor of this system
may be exposed to direct sunlight of
lighting.
The batteries may be worn out.
Cause
The characteristics of FM stereo
broadcasts may cause this problem when
the transmitter is too far away or the
antenna input is poor.
There is multi-path interference.
The signal is too weak.
This system has been disconnected for a
long period and preset station memory
has been cleared.
Cause
Solution
For information on the remote control operation
range, refer to "Remote control".
Change the lighting.
Replace the batteries.
Remedy
Check the antenna connections.
Try using a high-quality directional FM
antenna.
Use the manual tuning method.
Adjust the antenna position to eliminate multi-
path interference.
Use a high-quality directional FM antenna.
Use the manual tuning method.
Set preset stations again.
Remedy
Only iPod (Click and Wheel), iPod nano, and iPod
mini are supported.
Station your iPod back in a Yamaha iPod universal
dock (YDS-10, sold separately) connected to the
DOCK terminal of this system.
Additional information
See
page
5
—
5
See
page
12
—
17
—
—
17
18
See
page
—
12
27
En