Haier HWD120-B1558 User Manual page 34

9- Troubleshooting
9-3 Troubleshooting without display code
Problem
Appliance fails to
operate.
Control panel is out
of function
with water.
Appliance is draining
Drainage failure
Strong vibration while
spinning.
Operation stops
before completing
wash cycle.
Operation stops for a
period of time.
Excessive foam fl oats
drum and/or deter-
gent drawer.
Automatic adjustment
of washing time.
Spinning fails.
34
Cause
• Programme is not yet started.
• Door is not properly closed.
• Appliance has not been switched on
• Power failure.
• Child lock is activated
• Time delay is activated?
• Pause button is pressed?
• Child lock is activated?
• No water.
• Inlet hose is kinked.
•
• Water pressure is too low.
• Door is not properly closed.
• Water supply failure.
• Time delay is activated?
• Start button in not touched?
• Height of drain hose is below 80
cm.
• Drain hose end could reach into water.
• Drain hose is blocked.
•
• Drain hose end is higher than 100
cm above floor level.
• Not all transportation bolts have
been removed.
• Appliance has no solid position.
• Machine load is not correct.
• Water or electric failure.
• Pause button is pressed?
• Appliance displays error informa-
tion.
• Problem due to load pattern.
• Programme performs soaking cycle?
• Detergent is not a appropriate
• Excessive use of detergent.
• Washing programme duration will be
adjusted.
• Unbalance of laundry.
Solution
• Check programme and start it.
• Close the door properly.
• Switch the appliance on.
• Check power supply.
• Deactivate child lock.
• Deactivate time delay function.
• Deactivate pause modus.
• Deactivate child lock.
• Check water tap.
• Check inlet hose.
•
• Check water pressure.
• Close the door properly.
• Ensure the water supply
• Deactivate time delay function.
• Touch start button.
• Make sure that drain hose is
properly installed.
• Make sure the drain hose is not
in water.
• Unblock drain hose.
•
• Make sure that drain hose is
properly installed.
• Remove all transportation
bolts.
• Ensure solid ground and a ev-
elled position.
• Check load weight and balance..
• Check power and water supply.
• Deactivate pause modus.
• Consider display information.
• Reduce or adjust load.
• Cancel programme and restart.
• Check detergent recommen-
dations.
• Reduce amount of detergent.
• This is normal and doesn't af-
fect functionality.
• Check machine load and laun-
dry and run a spinning pro-
again. .
gramme
GB