9- Troubleshooting - Haier HWD120-B1558 User Manual

9- Troubleshooting

problem please check all shown possibilities and follow the instructions below before you
contact an Aftersales service. See CUSTOMER SERVICE.
WARNING!
Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
improper repairs can cause considerable consequential damages.
A damaged power cable should only be replaced by the manufacturer, its service
9.1 Information codes
9.1
9.2 Troubleshooting with display code
Note: Troubleshooting
If error information appears please press power button to get rid of it. If it keeps ap-
pearing, pull out power plug and contact customer service.
In case you are asked to contact the customer service: Note troubleshooting message
and refer to „CUSTOMER SERVICE".
Cause
Tip
code
The appliance cannot empty the
E1
water.
• The door is not locked.
E2
• The door has not unlocked.
E4
The water level is too high.
E8
Abnormal drying water level detected.
The water did not reach the correct
F3
temperature.
Heating system fault.
F4
32
Some displayed messages only refer to the washing
cycle (Fig. 9.1). No measures need to be taken.
Solution
and drain pipe are not blocked.
• Please open then close the door again and
press the OK key to start the selected pro-
gram.
•
Aftersales service.
Please check the water supply is available and
turned on, or if the water pressure is low.
pliance and contact Aftersales service.
tersales service.
GB
-
-