Advertisement
WARNING! If you come into contact with battery acid take immediate action:
a) Skin contact:Wash immediately with soap and water.
b) Eye contact: Flush eye immediately with cool, clean running water for at least 15 minutes and seek immediate medical attention.
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that may
occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but
must be applied by the operator
2. INTRODUCTION
Used to preserve the memory to on-board electronics whilst the vehicle's own battery is disconnected. Saves valuable time spent
re-programming lost codes. Can be connected via the vehicle's EOBD or accessory socket. Unit features an internal 12V 4Amp sealed battery
and LEDs provide battery condition and charge indicator. Supplied with mains charger.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . VS2071.V2
EOBD Lead Length:. . . . . . . . . . . . . . 1 . 4 m
Accessory Lead Length:. . . . . . . . . . . 1 . 4 m
Unit Charger:. . . . . 230V Input/12V Output
4. CONTENTS
fig.1
Refer fig.2 for
control panel
5. OPERATION
5.1.
CHARGING THE BATTERY PACK
NOTE: The unit battery pack will have been shipped in a low charge state. Charge the battery prior to first use.
5.1.1. Ensure that the power switch is in the 'OFF' position and the unit is disconnected from the vehicle.
5.1.2. Plug the charger into the charger adaptor and switch on the mains power supply. The red 'CHARGING' LED will illuminate whilst the
unit is charging. Once the unit has fully charged the green 'CHARGED' LED will illuminate.
5.1.3. If the yellow 'REPLACE BAT.' LED illuminates, the battery pack is unserviceable and must be replaced (refer to Section 6).
5.1.4. Once the unit is fully charged, disconnect from the mains supply and remove the charger from the charger adaptor.
5.2.
OPERATION
5.2.1. The VS7021 is supplied with 2 leads enabling connection using either the EOBD socket lead or the vehicle accessory socket
lead, refer to fig.1.
5.2.2. Ensure that the vehicle ignition switch is turned OFF.
5.2.3. Plug the lead into the output socket on the unit. DO NOT switch the power switch to the 'ON' position.
5.2.4. Connect the other end of the lead to the vehicle. The LED on the plug at the unit should illuminate red, indicating a voltage from the
vehicle. If the LED does not illuminate, check the connections at the vehicle and the unit.
5.2.5. Once the unit is connected to the vehicle press the power switch to the 'ON' position. The green 'BAT. OK' will illuminate, indicating a
good connection and adequate operating voltage in the battery pack.
NOTE: If the red 'BAT. LOW' illuminates, the battery pack will require charging. Press the power switch to the 'OFF' position,
disconnect from the vehicle and charge the battery (refer to Section 5.1.1.).
5.2.6. When connected to the vehicle with the green 'BAT. OK' LED illuminated, it is safe to disconnect the vehicle battery without
eliminating any codes.
© Jack Sealey Limited
.
Accessory Lead
Original Language Version
Battery Charger
EOBD Lead
VS2071.V2 Issue No: 1 - 23/10/14
Advertisement
