Advertisement
Before making connections, make sure that the
amplifier is switched off.
ICONNECTIONS
•
Connect the screw-type input terminals at the rear of the
speakers to the speaker output terminals of the amplifier
(or receiver) with the speaker cable.
• One side of the speaker cable is red and the other side is
black. Connect the (+) terminals on the amplifier (or
receiver) and speakers using the red side. Connect the
(–) terminals on both components using the black side of
the cable.
• Connect one speaker to the left (marked L) terminals of
your amplifier, and another speaker to the right (marked
R) terminals, making sure not to reverse the polarity
(+, –). If one speaker is connected with reversed polarity,
the sound will be unnatural and lack bass.
How to Connect:
1
Loosen the knob.
2
Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.
3
Insert the bare wire.
4
Tighten the knob and secure the cables.
Test the firmness of the connection by pulling lightly on
the cables at the terminal.
Speaker (R)
1
Red
R
Speaker output
–
terminals of the
SPEAKERS
amplifier (or
receiver)
Black
Amplifier or
Receiver
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker or the amplifier, or both
of them.
CONNECTIONS TO YOUR AMPLIFIER
Black
4
Speaker (L)
3
Red
L
–
Black
When using a banana plug
<
>
General model only
1
Remove the cover by pulling it toward you.
2
Tighten the terminal knob.
3
Simply insert the banana plug into the terminal.
Banana plug
2
I Using the non-skid pads
Put the provided non-skid pads at the four corners on the
bottom of speaker to prevent the speaker from moving by
vibrations etc.
3
1
Non-skid
pad
3
2
E-
E-
Advertisement
