Cisco Profile Series Getting Started Manual page 12

Profile Series, Codec C Series and Quick Set C20 / C20 Plus
Contents Introduction
CALL KEY: Press the Call key to
place a call, and to accept an
incoming call.
Use the Call button as a shortcut
to Recent Calls when the Call
menu is not visible.
CLEAR: Press the
Clear key to remove
characters in a text
field.
Waking up the system
To wake up the system just pick up the remote control or press any key. You may
have to point the remote control towards the system to make sure it discovers you.
Press the HOME
key to show the
Home menu on
screen.
Profile Series, Codec C Series and Quick Set C20/C20 Plus Getting Started Guide TC4.1, Feb 2011.
D14639.03
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
Configure your system Operating devices Operating devices
END CALL / STANDBY: Press the
End Call key to reject an incoming
call, to end an ongoing call or—when
idle—to go into standby mode. When
navigating in the menus the key is
used to exit the menu system.
Press and hold this key to have the
system enter standby mode.
When you pick up the
remote control and
touch the rubber line
sensors along the
sides of the remote
control, the system
wakes up.
The menu system
ALPHANUMERIC KEYPAD
The keypad behaves in a similar way to
the keypad of a cellular phone.
IR sensor range (DIP switch setting)
The IR sensor has a short and long range. When video systems are placed close to each other,
you may find it convenient to use the short range to avoid interfering with the other video
systems.
Open the battery cover and remove the batteries to set the DIP switch.
•
Short range (1 m / 3 ft): Move the DIP switch down.
•
Long range: Move the DIP switch up.
The DIP
switch
12
Getting started guide
The web interface Password protection
0-9, a-z, period (.), @,
space, *:
Press a key repeatedly to
toggle between the options
displayed on each key.
abc/123 #: Press and hold
the # key to toggle between
lower and upper case
characters and numbers
(depending on context).
www.cisco.com