Advertisement
Step 13
Carefully stand your unit upright.
å
Position your unit near its fi nal location.
å
Turn the ADJUSTABLE FEET (JJ) downward until they touch the fl oor.
å
IMPORTANT: The ADJUSTABLE FEET should not extend beyond the bottom edges
å
of the SIDE SKIRTS (R).
Before fastening the DOOR to your unit, be sure the mounting screw is
å
against the stops as shown in the left diagram. If it isn't, loosen the mounting
screw to slide it against the stops. Then tighten the mounting screw.
Fasten the LARGE DOOR (L) to the LARGE END (B) as shown in the lower
å
diagram. Use the screws in the HINGES. You should start each SCREW a few
turns before completely tightening any of them.
Fasten a PULL (X) to the LARGE DOOR (L). Use two BLACK 7/8" MACHINE
å
SCREWS (NN).
See the next step for DOOR adjustments.
å
L
X
www.sauder.com/services
B
SILVER 7/8" MACHINE SCREW
Turn the ADJUSTABLE FEET
R
downward until it touches the fl oor.
411572
LARGE DOOR ON LEFT
Stop
Mounting
screw
Hinge
NN
(2 used for the PULL)
JJ
Floor
Page 17
Advertisement
