MGI ZIP Series Installation

Seat, sand bucket loop, sand bottle installation

Hide thumbs Also See for ZIP Series:

SEAT, SAND BUCKET LOOP, SAND BOTTLE INSTALLATION

The seat for your MGI Zip Buggy is designed to be installed on the Right hand side of your buggy.

Once installed, your horizontal seat stem should look like the below image.

1. To insert the horizontal seat stem ensure the coloured leaver underneath the chassis is

unlocked as per the below image

2. Insert the seat stem through the chassis so that the end of bracket is positioned

approximately to the centre of the right hand wheel.

Table of Contents

Do you have a question about the ZIP Series and is the answer not in the manual?

Page 1 SEAT, SAND BUCKET LOOP, SAND BOTTLE INSTALLATION The seat for your MGI Zip Buggy is designed to be installed on the Right hand side of your buggy. Once installed, your horizontal seat stem should look like the below image. 1. To insert the horizontal seat stem ensure the coloured leaver underneath the chassis is unlocked as per the below image 2.
Page 2 3. Push the lever up until it clicks into position 4. You can now fit the seat onto the horizontal seat stem 5. If you also have a sand bucket loop or sand bottle, please see the below images for installation...
Page 3 6. Fit the sand bucket loop onto the left hand side of the seat stem and fasten the screw until firm. 7. Fit the sand bottle adaptor onto the left hand side of the seat stem and fasten the screw until firm 8.
Page 4 9. If you are fitting a sand bucket loop only, connect the loop to the bar supplied and fasten the screw until firm. Release the coloured lever underneath the buggy and insert the bar through the centre of the chassis 10.
Page 5 12. Push the lever up until it clicks into position 13. Insert sand bottle into the sand bottle adaptor...

Zip navigator