Sun Microsystems Sun Cobalt Control Station Maintaining And Upgrading The Hardware page 9

Be careful not to damage components during the upgrade.
Caution: Wear an electrostatic discharge (ESD) grounding wrist
strap.
!
1. Remove the PCI slot cover, and its retainer and screw. See Figure 2.
2. Remove the protective cover from the PCI connector.
3. Plug the PCI card into the PCI connector. See Figure 3.
4. Replace the PCI retainer and screw to hold the PCI card in place.
5. Save the PCI slot cover in case you want to remove the PCI card later.
6. Replace the top cover of the control station.
7. Secure the top cover properly and replace the ten screws that hold the top
cover in place. See Figure 2.
Upgrading the Hardware—Sun Cobalt Control Station
Adding a PCI card
5