Sun Microsystems SFP+ Installation Manual

For the sun blade 6000 virtualized multi-fabric 10gbe nem

SFP+ Module Installation Guide

™

for the Sun Blade

6000 Virtualized

Multi-Fabric 10GbE NEM

Installing the SFP+ Optical Transceiver Module

This network express module (NEM) requires that at least one small form-factor pluggable (SFP+) optical

transceiver module is installed in the NEM to enable a 10 GbE connection. One or more SFP+ modules is

provided with your system.

Refer to the following illustration and procedure for instructions on installing the SFP+ module.

Table of Contents

Do you have a question about the SFP+ and is the answer not in the manual?

Page 1 SFP+ Module Installation Guide ™ for the Sun Blade 6000 Virtualized Multi-Fabric 10GbE NEM Installing the SFP+ Optical Transceiver Module This network express module (NEM) requires that at least one small form-factor pluggable (SFP+) optical transceiver module is installed in the NEM to enable a 10 GbE connection. One or more SFP+ modules is provided with your system.
Page 2 ▼ To Install an SFP+ Optical Transceiver Module 1. Unpack the SFP+ optical transceiver module from the module packaging. 2. Pull the locking handle into the full horizontal position until you feel the handle click into position. 3. Remove the protective end cap. 4.
Page 3 Accessing Sun Documentation You can view, print, or purchase a broad selection of Sun documentation, including localized versions, at: http://www.sun.com/documentation Contacting Sun Technical Support If you have technical questions about this product that are not answered in this document, go to: http://www.sun.com/service/contacting Sun Welcomes Your Comments Sun is interested in improving its documentation and welcomes your comments and suggestions.
Page 4 Copyright 2008 Sun Microsystems, Inc. All rights reserved. Copyright 2008 Sun Microsystems, Inc. Tous droits réservés. Sun Microsystems, Inc. www.sun.com Part No. 820-6752-10, Rev. A December 2008...