Advertisement
SAFETY & WARNINGS
When not in use, keep this screen rolled up in its protective case. Always examine both the
front and rear of surfaces of the screen before rolling it up to ensure it is free of dust, dirt or
other foreign matter. Use a very soft duster to gently remove any foreign particles.
INSTALLATION
Note:
•
Select the appropriate mounting hardware according to your chosen
mounting location.
•
It is recommended to use a spirit level to ensure the screen is installed
straight.
•
The load-bearing capacity of the screw in the wall/ceiling needs to be at
least 7kg per side.
Flush Wall Mounted (additional hardware required)
1.
Using a tape measure, mark the keyholes that are located at the back of the
screen case end caps.
2.
Predrill the holes, insert the screws, leaving the screw head out approximately
4mm (1/8") from the wall to mount the screen on. (Figure 1)
Figure 1
Advertisement
