Medisana 85202 Manual page 16

GB
3 Operating
3.1
Getting started
3.2
Operation
12
IMPORTANT
Only use the mains adapter supplied, if you use the unit as a
mains operated unit.
If you want to use the unit cordlessly, i.e. without mains
adapter, the battery must first be charged for 16 hours.
CHARGING THE BATTERY
1. Connect the plug of the connecting cable into the socket
of the epilator.
2. Connect the mains adapter to the mains socket.
3. During charging, the red charge indicator
the unit for the first time let it charge for 16 hours. The unit will then run
for about 30 minutes on the battery charge.
4. Disconnect the mains adapter from the mains socket and then pull the
cable out of the socket
NOTES
Charge the battery again for 8 - 16 hours when its performance
falls off noticeably.
We recommend to completely discharge the unit occasionally to
increase the battery life. To do this, disconnect the mains adapter
from mains socket and unit. Then switch on the unit until the
battery is discharged.
If the unit is not fully charged, it can be used as a mains
operated unit by using the mains adapter.
1. Your skin should be clean, dry and free from creams, lotions, grease, oil and
dead skin.
2. Use the unit in a place with a pleasant temperature to avoid sweating.
3. Ensure that the unit is sufficiently well charged or has been connected to
the mains properly.
4. Remove protective cap
5. The unit has two speeds: a low speed for fine hair, thin hair covering and
skin above bones, such as knees and ankles, and a high speed for coarse
hair, larger areas of skin and stronger hair growth. Switch on the unit by
selected the speed required with the slider switch
0 : unit switched off
I : low speed
II : high speed
Slide the switch into the position required whilst simultaneously pressing
the button integrated into the switch.
is illuminated. When charging
on the unit.
from the unit by pulling it gently upwards.
at the bottom
.