Controls; Connection And Start-Up; Selecting Type Of Battery - Multiplex POWER PEAK A4 Operation Instructions Manual

Operation Instructions Power Peak

3. Controls

AC/DC operating
voltage connection
Power switch
PC-Port for
Service

4. Connection and Start-Up

The device can either be operated with 230 V AC
or 12 V DC.
To do so, use the power cable for AC operation
or the cable with XT-60 plug for DC operation
(possible in conjunction with the alligator clips)
included in the scope of delivery.
During connection, ensure correct polarity,
(red = + pole / black = - pole).
The device is protected against reverse polarity.
The charger is now operational.
12
A4
®
Regulator for Status LED
setting the
charging current
Start button
The battery is connected to the battery connec-
tion sockets mounted on the right side with the
charging cable provided.
Ensure correct polarity when connecting
(red = + terminal/black = - terminal).
Although the charger output is protected against
polarity reversal and short-circuits they should,
nevertheless, be avoided and, if necessary,
immediately rectified.

5. Selecting Type of Battery

The corresponding type of battery must be set
after switching on the charger. For this pur-
pose, with the battery not connected, press the
„START" button on the charger, until the required
type of battery is shown in the display.
Balancer
port
Battery
connection
sockets
red = +
black = -