EUFAB 13492 Manual page 5

• Never look directly into the light source and never direct the beam of light onto people or animals. The LED light may result
in injuries to the eyes.
• Never look at the light source using optical instruments. The LED light may result in injuries to the eyes.
• Always maintain a distance of at least 0.5 m between the working spotlight and the illuminated area.
• Always position the working spotlight on an even surface.
• Set the working spotlight up in such a way that it cannot become a trip hazard.
• During charging, lay out the charging cable in such a way that nobody is able to fall over it.
5. Explanation of symbols
6. Operating instructions
6.1 Overview
1. COB light field
2. Connection box
3. Switch
4. USB output (USB A)
5. USB input (USB Micro B)
6. Control lamp indicating USB output active
7. Control lamp indicating battery fully charged
8. Control lamp indicating charging process
9. Charging cable
10. Stand
6.2 Charging the battery
Open the lid of the connection box (Position 2 in the overview). Connect the USB input, Micro-B (Position 5 in the overview) to the USB
Micro-B connector of the charging cable (Position 9 in the overview). Connect the USB type A connector to a USB charger. You can use a
computer or the USB connection in your vehicle for charging purposes.
During the charging process, the charge control lamp (Position 8 in the overview) is lit in red. Once the battery is fully charged, the charge
control lamp goes out, and the battery full control lamp (Position 7 in the overview) is lit in green. After charging, remove the charging
cable from the connection box and close the lid.
6.3 Function
Setting up:
You can set the working spotlight up in position by folding out the stand (Position 10 in the overview) and adjusting to various angles, or
you can hang the device up.
Illumination:
• Pressing the switch multiple times (Position 3 in the overview) enables you to activate the following functions of the battery-powered
working spotlight:
• COB light field on (Position 2 in the overview)
• COB light field, dimmed
• COB light field, flashing light
• Off
Using as a portable charger:
You can also use the battery-powered working spotlight as a portable charger, for example, to charge a mobile telephone or USB device.
To do this, open the lid of the connection box. Connect the USB device using its USB cable. Plug the USB type A connector of the charging
cable of your USB device into the USB output (Position 4 in the overview). As long as the USB output of the working spotlight is being used,
the USB control lamp (Position 6 in the overview) is lit up in red. Once the battery of the USB device has been charged, the control lamp
will go out. After charging, remove the charging cable from the connection box and close the lid.
Figure 1: Overview
5