Table of Contents
Advertisement
Arpeggio playback
1
Select a Voice/Multi (pages 35, 43).
Turn the Arpeggio on by pressing
2
the [ARPEGGIO] button.
The LED lights, indicating that Arpeggio is set to on.
n If Arpeggio is switched on and ready for use, the
[ARPEGGIO] button LED will light when you select the
Voice or Multi.
n The on/off status of the [ARPEGGIO] button can be
stored as part of each Voice or Multi setup (page 57).
3
Play back the arpeggio.
Hold down a key or keys on the connected keyboard
(or use note data from a sequencer) to play back the
Arpeggio. The Arpeggio plays back according to the
note number, Arpeggio type, tempo, note limit settings,
and so on.
n In the Voice Mode, the Arpeggio is played back via the
selected voice.
n In the Multi Mode, the Arpeggio is played back via the
voice assigned to the selected part when the "ArpSwitch"
parameter (page 54) of the selected part is set to on.
n When you play back arpeggios that include control
change data, the Voice may be changed and the edit
indicator may appear in the top right of the display.
Change the Arpeggio
settings
A variety of Arpeggio types are provided with the
MOTIF-RACK. You can change the tempo of the
Arpeggio as desired. The Arpeggio function is available
in both the Voice and Multi modes.
The explanation below applies to the Multi mode.
1
Call up the ARP (Arpeggio) screen.
In the Voice/Multi mode, simultaneously hold down
the [SHIFT] button and press the [ARP EDIT] button.
2
Select an Arpeggio Bank.
Move the cursor to the "Bank" parameter (use the
cursor [ ][ ] buttons) and select the bank with the
data dial. There are two Arpeggio banks: pre1 (preset
1) and pre2 (preset 2).
53
Using the Arpeggio function
Advertisement
Table of Contents
