Digital Effects - Yamaha MG166C Owner's Manual

Digital Effects

1
2
3
4
5
6
0
* Only the MG166CX has digital effects.
1
FOOT SWITCH Jack
A Yamaha FC5 foot switch (sold separately) can be connected to this jack
and used to toggle the digital effects ON and OFF.
2
PROGRAM Dial
Selects one of the 16 internal effects. See page 19 for details about the
internal effects.
3
PARAMETER Control
Adjusts the parameter (depth, speed, etc.) for the selected effect. The last
value used with each effect type is saved.
NOTE
4
AUX Control
Adjusts the level of the signal sent from the internal digital effect unit to
the AUX buses.
NOTE
5
ON Switch
Switches the internal effect on or off. The internal effect is applied only if
this switch is turned on. The switch lights orange when on.
An optional Yamaha FC5 foot switch (sold separately) can be used to tog-
gle the digital effects ON and OFF.
7
NOTE
8
9
6
PFL Switch
Turn this switch on to send the effect signal to the PFL bus.
7
1-2 Switch
This switch assigns the effect signal to the GROUP 1/2 bus.
8
3-4 Switch
This switch assigns the effect signal to the GROUP 3/4 bus.
9
ST Switch
This switch assigns the effect signal to the STEREO L/R bus.
0
EFFECT RTN Fader
Adjusts the signal level sent from the internal digital effect unit to the STE-
REO bus.
When you change to a different effect type, the mixer automatically
restores the value that was previously used with that type (regard-
less of the current position of the PARAMETER knob).
These parameter values are reset when the power is turned off.
The signal level sent to the AUX buses is not affected by the
EFFECT RTN fader.
The ON switch lights and the internal effect unit is active when the
power is initially turned on.
MG206C/MG166CX/MG166C Owner's Manual
Reference
Front & Rear Panels
15