Master Control Section - Yamaha MG124C Owner's Manual

Reference
Front & Rear Panels

Master Control Section

2
1
3
4
9
0
A
D
E
G
F
* impedance balanced
Since the hot and cold terminals of impedance balanced
output jacks have the same impedance, these output
jacks are less affected by induced noise.
14
MG124CX/MG124C Owner's Manual
5
7
6
8
B
C
H
MG124CX
1
2TR IN Jacks
These RCA pin jacks can be used to input a stereo sound
source. Use these jacks when you want to connect a CD
player directly to the mixer.
You can adjust the signal level using the 2TR IN con-
NOTE
trol in the Master Control section.
2
REC OUT (L, R) Jacks
These RCA pin jacks can be connected to an external
recorder such as an MD recorder in order to record the same
signal that is being output via the STEREO OUT jacks.
The mixer's STEREO OUT Master Fader has no
NOTE
affect on the signal output via these jacks. Be sure to
make appropriate level adjustments at the recording
device.
3
RETURN L (MONO), R Jacks
These are unbalanced phone-jack type line inputs. The signal
received by these jacks is sent to the STEREO L/R buses and
the AUX (AUX1) bus. These jacks are typically used to
receive the signal returned from an external effect device
(reverb, delay, etc.).
These jacks can also be used as an auxiliary stereo
NOTE
input. If you connect to the L (MONO) jack only, the
mixer will recognize the signal as monaural and will
send the identical signal to both the L and R jacks.
4
SEND Jacks
• AUX (AUX1)
This is an impedance balanced* phone-jack type output. This
jack outputs the signals from AUX (AUX1) bus. You can use
this jack, for example, to connect to an effect unit, cue box,
or other monitoring system.
• EFFECT (AUX2)
This is an impedance balanced* phone-jack type output that
outputs the signal from the EFFECT (AUX2) bus. You can
use this jack, for example, to connect to an external effect
unit.
5
STEREO OUT (L, R) Jacks
These jacks deliver the mixer's stereo output. You can use
these jacks, for example, to connect to the power amplifier
driving your main speakers. You can also connect these jacks
to a recording device when you wish to record mixer's stereo
output while using the STEREO OUT Master fader for level
control.
• XLR jacks
XLR-type balanced output jacks.
• LINE jacks
TRS phone-jack type balanced outputs.
6
GROUP OUT (1, 2) Jacks
These impedance-balanced* phone jacks output the Group
1/2 signals. Use these jacks to connect to the inputs of a
multi-track recorder, external mixer, or other such device.
7
MONITOR OUT Jacks
Connect these stereo phone-jack outputs to your monitor sys-
tem.
The signal output by these jacks is determined by the
NOTE
MONITOR switch, the 2TR IN switch, and the PFL
switches on the input channels.