Front & Rear Panels
8 SEND Jacks
• AUX1, AUX2
These are impedance balanced phone-type output jacks.
These jacks output the signals from AUX1 and AUX2,
respectively. You use these jacks, for example, to connect to
an effector or monitor system.
9 RETURN L (MONO), R Jacks
These are unbalanced phone-type input jacks. The signal
received by these jacks is sent to the Stereo bus. These jacks
are typically used to receive a return signal from an external
effector (reverb, delay, etc.).
Connector Polarities
MIC INPUT
LINE INPUT (monaural channels),
ST OUT, C-R OUT,
AUX1, AUX2*
INSERT I/O
PHONES
RETURN,
LINE INPUT (stereo channels)
* These jacks will also accept connection to monaural phone plugs. If you use monaural plugs, the connection will be unbalanced.
1 2
MG10/2
20
Pin 1: Ground
Pin 2: Hot (+)
Pin 3: Cold (–)
Tip: Hot (+)
Ring: Cold (–)
Sleeve: Ground
Tip: Output
Ring: Input
Sleeve: Ground
Tip: L
Ring: R
Sleeve: Ground
Tip: Hot
Sleeve: Ground
Rear Section
These jacks can also be used as an auxiliary stereo
NOTE
input. If you connect to the L(MONO) jack only, the
mixer will recognize the signal as monaural and will
propagate the identical signal on both L and R
jacks.
0 PHONES Jack
Connector for headphones. This is a balanced phone-type out-
put jack.
1 AC ADAPTOR IN Connector
Connects to the included PA-10 power adaptor (see page 5).
Use only the PA-10 adaptor included with this mixer.
Use of a different adaptor may result in fire or electric
shock.
2 POWER Switch
Use this switch to set mixer power to ON or STANDBY.
Note that trace current continues to flow while the
switch is in the STANDBY position. If you do not plan
to use the mixer again for a long while, be sure to
unplug the adaptor from the wall outlet.
INPUT
OUTPUT
Ring
Sleeve
Tip
Sleeve
Tip