Installing The Fence Assembly; Miter Gauge Assembly - Skil RAS900 Owner's Manual

Installing the fence assembly

(Fig. 12 and Detail 12)
The fence comes assembled. Step 1 refers to
reassembly, if necessary; otherwise, go to Step
2 if already assembled.
1. Install spacers (31) on square-head bolts
(47) (Detail 12).
2. From underneath the fence, slide two 1/4-20
x 2-1/4" square-head bolts (47) with spacers
(31) up through the holes in the bottom of
the fence assembly (C). Loosely attach a
large clamping knob (21) onto each bolt
(Fig. 12).
3. Insert the square-head bolts (47) with
spacers (31) through the holes of the J-slots
on the tabletop (1), making sure the bolt
heads and spacers are below the inside
surface of the tabletop and can slide freely in the J-slot.
4. From the rear of the table assembly, slide the fence assembly (C) right and into the J-slot
and make sure that it slides smoothly from front to back.
5 Tighten the large clamping knobs (21) to secure the fence assembly (C) to a desired
position.
NOTE: Use the scale on the tabletop as a guide when aligning the fence for routing
operations. Once the fence is positioned and aligned correctly, tighten the clamping knobs
SECURELY.
Miter gauge assembly (Fig. 13)
The miter gauge assembly comes fully
assembled. If not, use the following instructions
to assemble it.
1. Insert tab on top of the miter bar (23) in the
hole in the bottom of the protractor head (24).
2. Insert the #10-24 x 1" carriage bolt (37)
through the square hole in the miter bar (23)
and slot in the miter gauge and secure with
the flat washer (33) and the small clamping
knob (25).
22
Fig. 12
31
47
DETAIL 12
Router removed for clarity
Fig. 13
24
23
TAB
21
C
A
J-SLOTS
25
33
37