Removing The Fence Assembly; Removing The Quick-Clamp Router Mounting Plate From Base Plate - Skil RAS900 Owner's Manual

Removing the fence assembly (Fig. 3)
The fence for your router table comes fully
assembled with the adjustable jointing fence
and overhead guard already in place. The
fence assembly is secured to the bottom of the
table for shipment and storage. The handle
for the router release mechanism passes
through a square hole in the base of the fence
assembly when it is in its stored position.
1. Loosen two small clamping knobs (5),
washers (25), and mounting brackets (4)
securing fence assembly (C) to bottom of
router table (1). Remove fence assembly (C)
from storage position under the router table
(1) and set it to one side (Fig. 3).
2. Tighten the small star clamping knobs (13) and fence retaining brackets (12) to secure the
brackets to the bottom of the table (1).
To reinstall the fence assembly for storage:
1. Make sure the two faceplates are positioned so they are completely together.
2. Position the fence assembly (C) so the square hole is on the same side as the router
release mechanism (5). Slide the fence under the tool box so that the square hole fits over
the handle of the router release mechanism and position the fence assembly flat on the
underside of the table (1).
3. Position the two fence retaining brackets (12) over the corners of the fence assembly and
tighten the small star clamping knobs (13) to secure.
NOTE: Shim plate can be stored on outfeed side of the fence assembly.
Removing the quick-clamp router
mounting plate from the base
plate (Fig. 4 and Detail 4)
This router table is provided with a quick-
clamp router mounting system. The utilization
of this system requires the installation of a
router mounting plate to the router base. The
mounting plate has predrilled holes in it that
will match up with the mounting holes in most
standard routers.
1. Push latch spring away from clamp handle
to release the handle (Detail 4).
2. Push clamp handle away from Quick-Clamp
Base to open the router release mechanism
(5).
3. Pull the tab on the router mounting plate (4),
closest to the clamp handle, towards the
handle and down to remove the mounting
plate from the base plate (Fig. 4).
18
Fig. 3
C
5
Fig. 4
DETAIL4
Latch Spring
12
4
5
Clamp
Handle
13
1