Multi-Track Recording & Playback - Yamaha Clavinova CVP-89 Owner's Manual

36
Performance Memory
B
N
M
<
Z
X
C
V
Play on the keyboard. Recording will begin automatically as soon as you start
playing.
Stop recording by pressing the [START/STOP] button or the [REC] button.
When recording has finished the indicator of the recorded track will glow green,
indicating that the track is ready for playback.
Press the [START/STOP] button to play back your recording. Play along on the
keyboard if you like. During playback you can use the [PAUSE], [REW], and [FF]
buttons, as described on page 34. You can also change the playback tempo via the
TEMPO [ ] and [ ] buttons.
Playback will stop automatically when the end of the recording is reached, or
you can press the [START/STOP] button to stop it at anytime.
If you haven't already done so, make sure that a properly formatted disk is
loaded into the Clavinova disk drive (see page 48), and that the disk's write protect
tab is set to the "write" position (tab closed).
Select a SONG NUMBER between 1 and 60 for the piece you are about to
record (up to 60 different songs, each with a different song number, can be re-
corded on a single disk). Make sure the song number you select has not already
been used for a song previously recorded on the disk you are using.
Set up all necessary performance features as required: voice, voice mode (nor-
mal, dual, or split), style, tempo, etc. Try out the features as you select them to
check that you have the right overall sound.
Press the [REC] button so that its indicator lights. The [RIGHT/1] indicator
should also glow red at this point, indicating that you are ready to record on track
1. As soon as you release the [REC] button the first dot of the beat indicator will
begin to flash at the currently set tempo.