Z/U Axis; Files System - Trocen AWC608C Manual

Version of 【Main Board】can be upgraded by【UDisk file】to the newest one. （Refer to 7.4.1.3
System upgrade file）

7.5 Z/U axis

Under the main interface, press
Press or
When select【Auto focus】and press
(Refer to: 3.3.3.2), stop till touch Z+ limit switch, and then move the distance as in【Focus distance】in
opposite direction.(Refer to: 7.4.2)
When select【ZU move】,and press
stops moving.
Press or , U-axis starts to move, release

7.6 Files system

Under the main interface, press
LASER ENGRAVING&CUTTING CONTROLLER AWC608
、
:
to move cursor to select one item
or
, Z-axis will move at the speed of 【Z-axis reset speed】
, Z-axis starts to move, release
or , U-axis stops moving.
to enter into 【file】interface:
78
or , Z-axis