Unpacking; Installation; Trademarks; Powering Up A Cbx-D5 System - Yamaha CBX-D5 Operating Manual

2 2 2 Chapter 1 : Introduction Chapter 1 : Introduction Chapter 1 : Introduction

Unpacking

The CBX-D5 packaging should contain the following items.
Store the packaging materials for future use.

Installation

The cosmetic appearance of the CBX-D5 has been designed to match typical computer
hardware. Its "footprint" size matches that of many computers so that it can easily be
installed with your other computer equipment.
The CBX-D5 should be placed on a flat, stable surface.
The CBX-D5 can also be rack mounted using the supplied rack-mount kit. When installed
in the rack-mount kit the CBX-D5 requires 3U of rack space.

Trademarks

IBM , PC-AT , PS/1 , and PS/2 are registered trademarks of International Business
Machines Corporation.
Apple and Macintosh are registered trademarks of Apple Computer, Inc.
Atari , ST , TT , and STE are registered trademarks of Atari Corporation.
Mark of the Unicorn is a registered trademark of Mark of the Unicorn, Inc.
All other trademarks are the property of their respective holders.

Powering up a CBX-D5 System

Some computer systems are a little bit fussy about which devices are switched on first,
especially when a SCSI daisy chain is introduced into the system. As a good rule of
thumb, switch on all connected SCSI devices first, then the computer.
1 CBX-D5
1 Power cable
1 8-pin mini DIN cable
1 MIDI cable
1 SCSI cable (50 to 50 Amphenol)
1 SCSI terminator
1 Rack-mount kit (L & R set)
Hardware Test Program Disk
1
Test Program Manual
1
1 This Operating Manual
1 System Setup Guide
1 User Registration Card
NOTE: While using your CBX-D5 computer music system, do not switch off or
disconnect any device connected in the SCSI chain. Doing so will probably
lead to a system crash and you could loose valuable data.
Serial No: