Ph (Phaser) - Boss GT-6 GT-6 Owner's Manual

● SYN; Guitar Synth
Sensitivity
Wave
Chromatic
Octave Shift
PWM Rate
PWM Depth
Cutoff Frequency
Resonance
Filter Sensitivity
Filter Decay
Filter Depth
Attack
Release
Velocity
Hold
Synth Level
Direct Level
● SEQ; Sub Equalizer
Low EQ
Low-Middle Frequency
Low-Middle Q
Low-Middle EQ
High-Middle Frequency
High-Middle Q
High-Middle EQ
High EQ
Level
On/Off (effect on/off)
Switches the FX-2 effect on/off.
FX Select (effect select)
This selects the effect to be used.

■ PH (Phaser)

By adding varied-phase portions to the direct sound, the
phaser effect gives a whooshing, swirling character to the
sound.
Type
Selects the number of stages that the phaser effect will use.
4Stage:
This is a four-phase effect. A light phaser effect is obtained.
8Stage:
This is an eight-phase effect. It is a popular phaser effect.
12Stage:
This is a twelve-phase effect. A deep phase effect is obtained.
0–100
Square, Saw, Brass, Bow
Off, On Wave= Square, Saw
0, -1, -2 Wave= Square, Saw
0–100 Wave= Square
0–100 Wave= Square
0–100
0–100
0–100
0–100
-100 –100
Decay, 0–100
0–100
0–100
Off, On Wave= Square, Saw
0–100
0–100
-20 dB–+20 dB
100 Hz–10.0 kHz
0.5–16
-20 dB–+20 dB
100 Hz–10.0 kHz
0.5–16
-20 dB–+20 dB
-20 dB–+20 dB
-20 dB–+20 dB
Chapter 4 The Effects Explained
Bi-Phase:
This is the phaser with two phase shift circuits connected in
series.
Rate
This sets the rate of the phaser effect.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 46) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the cycle to
one-half or one-fourth of the BPM when the set cycle rate is
increased).
When setting to BPM, press PARAMETER [
the Master BPM settings screen.
Depth
Determines the depth of the phaser effect.
Manual
Adjusts the center frequency of the phaser effect.
Resonance
Determines the amount of resonance (feedback). Increasing
the value will emphasize the effect, creating a more unusual
sound.
Step
This sets on/off of the step function. When the step function
is turned on, the change of a sound will be in steps.
Step Rate
This sets the cycle of the steps that changes the rate and
depth. When it is set to a higher value, the change will be
finer.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 46) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the cycle to
one-half or one-fourth of the BPM when the set cycle rate is
increased).
When setting to BPM, press PARAMETER [
the Master BPM settings screen.
Effect Level
This adjusts the volume of the phaser.
Direct Level
This adjusts the volume of the direct sound.
] to display
] to display
37