Advertisement
Install...
1) Find your install diagram in this manual
1) Find your install diagram in this manual
- Get pickup wire colour codes from your pickup builders manual
- Get pickup wire colour codes from your pickup builders manual
2) Clip your output, ground & pickup wires from your old harness.
2) Clip your output, ground & pickup wires from your old harness.
as close to the harness as possible // DO NOT remove ground wires at guitar end)
as close to the harness as possible //
3) Strip back wire insulation leaving 6mm (1/4") of bare wire.
3) Strip back wire insulation leaving 6mm (1/4") of bare wire.
Strip too short // Cloth wire – pull the cloth back between your fingers)
Strip too short // Cloth wire – pull the cloth back between your fingers)
4) Press & hold connector button with a fine screw driver.
4) Press & hold connector button with a fine screw driver.
5) Insert wire into corresponding connector slot & release button.
5) Insert wire into corresponding connector slot & release button.
Release wires - Press & hold button)
Release wires - Press & hold button)
6) Test each wire for a secure connection.
6) Test each wire for a secure connection.
7) Re-assemble, string up, and enjoy.
7) Re-assemble, string up, and enjoy.
Troubleshooting // Page 16
DO NOT remove ground wires at guitar end)
DO NOT remove nuts from harness
(Cut
(Cut
( ( DO NOT
DO NOT
(To
(To
Advertisement
