Mounting And Installation; Configuration - Pepperl+Fuchs KCD2-RR2-Ex1 Manual

Functional Safety KCD2-RR2-Ex1(.SP)

Mounting and Installation

4 Mounting and Installation
Mounting and Installing the Device
1. Observe the safety instructions in the instruction manual.
2. Observe the information in the manual.
3. Observe the requirements for the safety loop.
4. Connect the device only to devices that are suitable for this safety application.
5. Check the safety function to ensure the expected output behavior.
4.1

Configuration

Configuring the Device
The device is configured via DIP switch. The DIP switch is on the front of the device.
The switch position of the DIP switch on the device has no influence on the safety function.
1. De-energize the device before configuring the device.
2. Open the cover.
3. Configure the device via the DIP switch.
4. Close the cover.
5. Secure the DIP switch to prevent unintentional adjustments.
6. Connect the device again.
Note!
See corresponding datasheets for further information.
13