Evenflo ExerSaucer Safari Friends Instructions Manual page 4

Assembling the ExerSaucer
C
B
A
C
B
D
E
E
B
A
A
2. Insert a foot C into the bottom of the pylon
Secure with one 8-16 X 75 mm screw
8-16 X 18 mm screws
do not overtighten. DO NOT USE POWER TOOLS.
IMPORTANT: The foot MUST sit completely flat in the bottom
of the pylon. If it is raised on either end, then one of the
stabilizer tubes is not installed correctly or is not fully inserted.
If this is the case, remove the stabilizer tube and reinstall until
the foot fits over it correctly.
3. Locate the other two pylons
upside down and completely insert the end of a stabilizer
tube A in each pylon, as shown.
Make sure the stabilizer tubes are fully inserted into the
bottom of each pylon.
4. Locate the third stabilizer tube
pylons B , as shown.
Make sure the stabilizer tube is fully inserted into the
bottom of each pylon.
B
2
B
D and four
E . Tighten all five screws securely but
B . One at a time, turn them
A and insert into both
, as shown.