Table of Contents
Advertisement
Outdoor Mounting Accessories – Junction Box DJB-115W
2
Safety Instructions
Only use the unit if it is technically in proper working condition and for the intended pur-
pose while keeping safety and potential dangers in mind.
Qualified Personnel
The installation, mounting, connection, commissioning and configuration of the unit may
only be carried out by qualified personnel.
This also applies to the maintenance, testing and repair, whereat the regulations of the
DIN VDE 0701 series of standards (repair, modification and inspection of electrical appli-
ances) must be followed.
Regulations
The use of video and audio surveillance systems is, in general, strictly regulated.
Inform yourself about the currently valid laws and regulations regarding data, worker and
environmental protection before using the unit and ensure compliance with them.
System Components
Only use internal components that have been tested and approved by Dallmeier.
Inappropriate internal components can cause malfunctions, damages and data loss and
can result in the loss of warranty.
Modifications
Do not make any modifications to the hardware or software that has not been tested and
approved by Dallmeier.
Inappropriate modifications can cause malfunctions, damages and data loss and can
result in the loss of warranty.
Documentation
Read the documents included in delivery carefully and thoroughly.
Always observe the contained instructions, notes and warnings.
Condensation Water
If the unit is brought from a cold to a warm environment, resulting condensation water can
cause malfunctions and damages.
In this case, wait (up to 8 hours) until the unit has reached room temperature before com-
missioning.
earthing & equipotential Bonding
For the safety of persons (protection against dangerous contact voltages) and devices
(protection against overvoltages) and the immunity of information and communication
technology equipment to electromagnetic interferences (EMI), all protective measures,
which are specified by the currently valid DIN, VDE and ISO standards and which provide
for a standard-compliant earthing and a correct equipotential bonding of electrical and
electronic devices, are mandatory and must be fulfilled by all means.
6
www.dallmeier.com
Advertisement
Table of Contents
