C) Placement Of The Lines From The Sensors/Alarms To The Alarm System; D) Mounting The Alarm System - Renkforce MAC-608 Operating Instructions Manual

We recommend reading the information on the different functions of the alarm zones completely before
setup.
Once a proper mounting size has been found and the length and core number of the lines required for con-
necting the sensors/alarms has been determined, mounting may commence.
Before the alarm system is installed, the cable for the mains connection and the connection lines
of the sensors/alarms must be guided through the intended round opening at the centre of the
rear of the housing from the back. Covered placement of the cables (e.g. in-wall) is important to
prevent sabotage. Connection to the mains and the lines of the sensors/alarms is established
after mounting.
If required, mark the respective line ends when placing the lines to be able to assign the connec-
tion lines to the sensors.

c) Placement of the Lines from the Sensors/Alarms to the Alarm System

First install the sensors/alarms to be connected to the alarm system in the intended locations in the build-
ing. Observe the assembly and operating instructions of these products.
Place the required lines from the sensors/alarms to the site of the alarm system concealed (e.g.
in-wall) so that you can connect them after the alarm system is installed.

d) Mounting the Alarm System

• Open the front flap of the housing with the enclosed key.
• The alarm system has four assembly holes in the back for mounting.
• Guide the already.placed lines through the intended round opening in the middle of the back wall of the
housing.
• Attach the housing to the wall with suitable mounting material. Use the screws and dowels included in
the delivery if necessary.
26