Dayasa GongTimer Manual page 9

Note: You may change these parameters by pressing the Menu button until you
reach the icon symbolizing the setting you wish to change.
4. S S
TART AND TOP THE SESSION
You are now ready to start the session. Press the button / (play)
The icon  is now displayed on the screen as well as the total duration of your
session. Ten seconds later, three sounds will signal the beginning of your session.
The number of minutes displayed on the screen will decrease every minute. When
00 is displayed, another three sounds will signal the end of your session. Then the
timer will stop automatically.
5. D S
URING THE ESSION
1) Pause: To pause during the session, just press the / button. The  icon
will start flashing.When you are ready to resume, press the /
again. The  icon will stop flashing and the session will continue where it was
stopped.
Note: After 20 minutes pause the timer will stop automatically.
2) Volume: To change the volume, simply press the + button to turn the volume
up or the – button to turn it down.
3) Stopping the timer: Press the ON/OFF button
Note: The latest settings will be automatically recorded. If you wish to use them
during your next session just turn on the Gong Timer, press the / button and
the session will start.
until the screen goes blank.
9
button